%=============================================================================
% cut.sty
%=============================================================================
% leftfigure, rightfigure, lefttable, righttable : produces a 'cut' at the
% right or left of the text.
%   by tsato@kuee.kyoto-u.ac.jp (Toru Sato)
%      Department of Electrical Engineering II, Kyoto University
%      Kyoto 606-01, Japan
%
%   Usage:  \begin{leftfigure}{width}{lines}
%             <figure body>
%           \end{leftfigure}
%           <a paragraph>
%   Example:
%         ...preceding text...
%
%         \begin{leftfigure}{60mm}{12}
%         \vspace{35mm}
%         \caption{This figure has width of 60mm and height of 12 lines.}
%         \end{leftfigure}  % note that here should not be a blank line
%         This text comes at the right of the figure.
%         If the text in this paragraph is not long enough to cover the height
%         of the figure, use
%         \Par
%         Command to connect the next paragraph.
%
%   Limitations:
%      1) It must be placed at the top of a paragraph, and the effect is
%         limited inside the paragraph (so you should not put a blank line
%         after \end{left|rightfigure}). Connect following paragraph(s) by
%         \Par command in place of a blank line, if it is necessary.
%         Naturally, one paragraph can contain only one left|rightfigure.
%      2) It cannnot handle end-of-page problem. You have to place it at the
%         right place so that entire lines are put on one page.
%      3) You have to specify the vertical size by the number of lines.
%         Although the paragraph may contain equations, each displayed
%         equation should be counted as 3 lines.
%      4) Ordinary \caption command can be used for a caption, and numbering
%         is made properly. It is possible to put it among ordinary figures,
%         but there is no guarantee that the order of the figures is kept
%         right.
%      5) The paragraph should not be the last paragraph of the document.
%=============================================================================
\newdimen\lfsep
\lfsep=3ex       % separation between the figure/table and text/margin
%=============================================================================
\def\leftfigure#1#2{\makeblank{#1}{#2}{#1}
\begin{nullfloat}{figure}{#1}{-#1}}
% next \def puts the following paragraph BEFORE the closing procedure
\def\endleftfigure#1 #2\par{\end{nullfloat}#2\par#1}

\def\rightfigure#1#2{\makeblank{#1}{#2}{0pt}
\@parwd=\textwidth \advance \@parwd by -#1
\begin{nullfloat}{figure}{#1}{\@parwd}}
\def\endrightfigure#1 #2\par{\end{nullfloat}#2\par#1}

\def\lefttable#1#2{\makeblank{#1}{#2}{#1}
\begin{nullfloat}{table}{#1}{-#1}}
\def\endlefttable#1 #2\par{\end{nullfloat}#2\par#1}

\def\righttable#1#2{\makeblank{#1}{#2}{0pt}
\@parwd=\textwidth \advance \@parwd by -#1
\begin{nullfloat}{table}{#1}{\@parwd}}
\def\endrighttable#1 #2\par{\end{nullfloat}#2\par#1}
%=============================================================================
% nullfloat : produces a table or figure whose size is 0pt x 0pt
\def\nullfloat#1#2#3{\def\@captype{#1} % #1=figure|table #2=width #3=lines
\noindent\leavevmode\hbox to 0pt \bgroup \hskip\lfsep\hskip #3
\vbox to 0pt \bgroup \hsize #2 \advance \hsize -2\lfsep
\textwidth\hsize\columnwidth\hsize \@parboxrestore}
\def\endnullfloat{\vss\egroup\hss\egroup\vskip-\baselineskip}

% makeblank : make a blank space at the right or left of text
\newdimen\@parwd \newcount\@nlp \newcount\@nlpi
\def\rightblank#1#2{\makeblank{#1}{#2}{0pt}}
\def\leftblank#1#2{\makeblank{#1}{#2}{#1}}
\def\makeblank#1#2#3{ % #1=width #2=lines #3=indent
\@parwd=\textwidth \advance \@parwd by -#1
\@nlp=1 \@nlpi=#2 \advance \@nlpi by 1
\edef\@PS{\parshape=\@nlpi}
\loop\ifnum\@nlp<\@nlpi \advance \@nlp by 1 \edef\@PS{\@PS #3\@parwd}\repeat
\edef\@PS{\@PS 0pt\textwidth} \@PS}
\def\Par{\\[\parskip]\hspace*{\parindent}}
%=============================================================================